ATA Ptx 4 Compatible Garage Door Remote - ATA Securalift Garage Door Remotes
ATA Ptx 4- 433 mhz Garage Door Remote Control
*REPLACED BY OUR STYLISH BLACK/SILVER REMOTE WITH SLIDING COVER*
or four payments of $14.23
with 
Learn More
You Will Receive Our Well Made Replacement Remote Control Which Has A Sliding Cover To Prevent Accidental Button Pushing And Protects The Remote From Weather Etc
Information
This Is Now Replaced By A Very Nice Stylish Key Ring 4 Button Garage Door Remote In 2nd Photo
Works Up to 4 Garage Doors Or Gates
PTX-4/PTX4
This transmitter is compatible with the following ATA SECURALIFT openers:
- Panelift garage door opener GDO-2V5, GDO-2V6, GDO-2V7, GDO-7,
- Roller garage door opener GDO-6, GDO-8, GDO4V3, GDO4V4, GDO4V5, GDO4V6, GDO2V5, GDO2V6, GDO2V7, GDO7, GDO7V1
- Roller garage door opener EASYROLLER GDO6, GDO6V2,GDO 6V3(If blue or green ariel you will need ptx5), GDO-8, GDO-8V2, GDO4V3, GDO4V4, GDO-9V1
- Gate SGO-1
Coding Instructions
ATA-PTX4 Programming Procedure
|
Art: PTX4 DESCRIPTION • Automatic Technology - 4 channel garage remote • Uses SecuraCode® code hopping technology • Controls up to 4 different doors or gates • Suitable for pocket, or key chain COMPATIBILITY • Suits Models: All ATA 433.92MHz Door Motors, ATA GDO-2 v5, v6, v7, ATA GDO-4 v3, v4, v5, v6, ATA GDO-6 v1, v2, ATA GDO-7 v1 SecuraLift II, ATA GDO-8 v1, v2, ATA GDO-9 v1. Not compatible with TrioCodeTM Garage Door Motors. Remote Programming Steps Storing Transmitter Code PTX4 1. Press and hold the blue ‘Door Code’ button on the opener or ‘SW1’ or ‘SW2’ on the receiver board. 2. Press the remote button you would like to use for 2 seconds. 3. Release the remote button and wait for 2 seconds. Press the same button again for 2 seconds. 4. Release the ‘Door Code’ or ‘SW’ button’. 5. Press transmitter to test.
Storing Transmitter from a Remote Location PTX4 1. Take any precoded transmitter. Press the button which functions the door/gate motor and release after activation. 2. Insert a small needle into the ‘Coding Hole’, press and hold firmly. 3. Within 10 seconds using your new remote, press and hold the button you would like to use for 2 seconds. 4. Release the remote button and wait for 2 seconds. Press the same button again for 2 seconds. This button should now be coded. 5. Wait for 10 seconds. Press transmitter to test.
Deleting Remote Controls from your Motor 1. Turn off the power to the opener 2. Press and hold the blue ‘Door Code’ button on the opener or ‘SW1’ on the receiver board. 3. Turn on the power on again, while holding the button. The coding LED will illuminate to show the memory has been cleared |
Reviews
Product Enquiry
Contact Details
Request More Information
Details of the product above will be automatically included with your enquiry.
View your shopping basket or Browse other items in ATA Securalift Garage Door Remotes.