B&D CAD 601 - B&d Garage Door Remotes
B&D 433mhz Garage Door Remote Control
This Is Obsolete And Now Replaced By Our Very Stylish Slim Line Aftermarket Replacement In 2nd Photo
or four payments of $16.98
with 
Learn More
Information
BND 433MHZ REPLACEMENT REMOTE
This Cad 601 Remote Is Replaced By Our Very Well Made Stylish Key Ring Remote Control In 2nd Photo.
Works Up To 4 Garage Doors Or Gates.
Compatibility:
- 062162
- 059116
- 059120
- 062170/433EBD (Remote)
- 062200/4410EBD
- 062199/4410EBD
- Controll-A-Door 4 (CAD4) - If your original remote has two buttons with ridges/grooves on the left button then your motor is not compatible.
- Controll-A-Door 5 (CAD5)
- Controll-A-Door R (CAD R)
- Controll-A-Door P (CAD P)
- Controll-A-Door Shed Master
- FAM4
- FAM5
- FAM P
- FAM RDO
- EL4
- EL5
- EASYLIFTER
- FIRMAMATIC SDO
- FIRMAMATIC RDO
- FAM R
- EL R
- RDO-1V1
- Not Compatible with other brand motors
- Not Compatible with 27MHz remotes (this will either be on the back or inside your remote)
- Not Compatible if remote has DIP switches (7-12 little switches inside the remote)
- Not Compatible with 062150 remotes (this remote looks similar remotes pictured in our listing, but has ridges/grooves on the left button)
Coding Instructions
How to store the transmitter code: The opener can only operate from transmitters that have been programmed into its receiver. The receiver needs to learn the codes of any transmitter that will be used with the opener. Up to fourteen (14) codes can be stored in the receiver's memory.
a. Go To The Garage Door Motor In Garage And Locate Learn Or Code Set Button
Controla door for =square green button on back motor panel
Cad-p diamond=orange square button on back panel
Roller door motors=code set button on side of motor
1. Press and hold the button on the hand-held remote* that you wish to operate your garage door.
2. Press and release the Learn button on the back panel of the opener.
3. The light globe will blink when the code has been accepted. If the light globe is not installed, two clicks will be heard.
To Erase All Codes From Opener Receiver Memory
To deactivate any unwanted remote, first erase all codes:
1. Press and hold the “Smart” button on opener until the smart indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.
Reviews
Product Enquiry
Contact Details
Request More Information
Details of the product above will be automatically included with your enquiry.
View your shopping basket or Browse other items in B&d Garage Door Remotes.